Help With New Tank Plumbing

[packman9111]

What you mainly see is DIY overflows made from half of hob overflow with 1" drains to basement sump. You can see plumbing for closed loop which consists of older 900gph quiet one pump thru 3/4 pvc to SCWD and return half way down in each corner. The return from sump in basement is via Iwiki 70RLT, 1" output, thru ball valve then transition to 1-1/4 PVC, up about 11-12 ft head and 4 45deg elbows to "T". I had then planned on trasition back to 1" after the "T" and plumbing to each corner near the return for the CL.
--Does that sound like a good plan?
--Would you do it differently?
--Do you think the flow will be sufficient?
Thanks Rick

http://mywebpages.comcast.net/packman1/images/CL1.JPG

http://mywebpages.comcast.net/packman1/images/CL2.JPG

 

[Len]

I'll copy this over to the DIY forum to get more input. I'll also try to revisit your thread later today to see if I can help (too busy this morning )

 

[packman9111]

Thanks!

Might help to know that it's a 110g! Some of you may remember that it's the one I rebuilt.

Rick