OK ALL YOU LED GURU's,
Here's my problem.. I just finished building my 1st DIY LED project with 72 LEDs 1:1 mix and 6 eln 60-48p drivers and I adjusted the CW to 950ma and the RB to 700ma. Now the problem that I seem to be having is 2 of the CW drivers still produce about 26vdc when the PWM voltage is removed and the LEDs stay on but very dim I was wondering if there is some other adjust I can do to correct this issue or is the driver bad. The PWM voltage is supplied by the Reef Angel controller and it is responding correctly at 10%=1vdc and 100%=10vdc and if I remove the PWM voltage completly the leds still stay on
HELP PLEASE
Here's my problem.. I just finished building my 1st DIY LED project with 72 LEDs 1:1 mix and 6 eln 60-48p drivers and I adjusted the CW to 950ma and the RB to 700ma. Now the problem that I seem to be having is 2 of the CW drivers still produce about 26vdc when the PWM voltage is removed and the LEDs stay on but very dim I was wondering if there is some other adjust I can do to correct this issue or is the driver bad. The PWM voltage is supplied by the Reef Angel controller and it is responding correctly at 10%=1vdc and 100%=10vdc and if I remove the PWM voltage completly the leds still stay on
HELP PLEASE
