- Location
- long island
Hey guys , I have a question has anyone used the Klir filter roller in a innovative marine 30L. If so how was the fitment? Any issues? I’m assuming it might fit in the 1st chamber .
Klir filter roller
- Thread starter infinity1
- Start date
They are meant to be used as a drop in replacement for a 4 or 7 inches sock, the only thing to watch out for is the height if there is a limit to that. But then again, they made the upper part (where the lip of the filter sock would be the divider) rotate 90 degrees so that it can be easier to install.
Something else that is important: if you want to run it as intended (rather than on a timer), with the water level sensor, you need to be able to have it in a place where water can raise up to about an inch.
Something else that is important: if you want to run it as intended (rather than on a timer), with the water level sensor, you need to be able to have it in a place where water can raise up to about an inch.
- Location
- long island
I think it’s cutting it close, I might be able to pull
It off.
It off.
Sponsor Reefs
We're a FREE website, and we exist because of hobbyists like YOU who help us run this community.
Click here to sponsor $10:
