30" cube stand. Will it work?

[bad coffee]

I'm trying to maximize the space under the stand of a 30x30x24" cube (95Gal.)

3/4" furniture grade ply, 34" tall stand. All joints will be pocket hole construction. Glue, and screws about every 8" or so.
Rails are 4" (top one is drawn as 2")
Styles are 2"

The bottom is set 1" above the floor, so the stand rests on just the edges. I might put a spacer in the center of the panel to hit the floor.

The doors will be on with magnets. The inside will be white garage-floor epoxy paint, and the bottom will be siliconed to hold any spillage.

Any other thoughts?

 

[cali_reef]

I made one with similar construction with 3/4 ply, I went with 4" wide doubled up 3/4 ply for the legs on the front. it racks slightly from front to back direction, hope the face frame will reduce that or I'll have to go with a few triangle brace on the corners.

I can take a few pictures of the stand for you, or you can find a full stand and tank shot in my cube tank thread.

 

[bueller]

looks fine to me.

bueller

 

[House of Laughter]

consider putting a tank on it

Jim

 

[tosiek]

a 1k lb tank none the less. And its built. he made a post showing it and modified it to strengthen it.