Recent content by mutley29

Took the words right out of my mouth Louey. Nice tank Waz.

Beautiful Tank. Great growth and colour, might have to upgrade my regular hydra's to 52's. :D

Hi David Thanx for the reply, the section that holds the grommets has worn away and is basically now a C shape, as far as i can tell i have no way of fixing it, though any hints pointers would be great as am more than willing to try. I read the article about the new ceramic bearings, at work...

Found my aquabee on my deltec 601 ca reactor had stopped working last night, and after stripping it down to try and locate the problem found that at the bottom of the pump where the shaft sits had been worn away on one side, meaning the magnet comes into contact with the inside of the shaft...

Thanks for all the replies guys, and please keep them coming :D My tank is 8ft wide (tank is in-wall, so looking at it from front is 8ft across ), and my flow patterns are in serious need of improvement, several of my fellow reefers in Northern Va use the Vortechs but they have narrower tanks...

I have a quandry, which should i get, Tunze have been around for some time, have great reliability and directional flow, where as the vortechs give awesome wave action etc, and have minimal intrusion into the tank (wetside assembly) I have a 96" X 25" X 27" tank with a Reeflo Dart on a OM 4...

Sweet Thanx Ape, i missed that thread Details forwarded :wink:

Not sure if this has been done or touched on before, i tried searching but was snowed with what came up in my search results. Is there a list of Tank Manufacturers, i know of AGA, Oceanic, Glasscages and have heard of a few more but am unable to find them, a buddy of mine with a 90 is moving...

Broke my Ph probe yesterday trying to get it out of the fitting i have it in for inline use :( and was wondering if anyone has any info on these Ph probes http://www.bulkreefsupply.com/PH/ORP/TDS-Monitors-&-Controller-Generic-Probes/c66_84/index.html Also how bad is the fluid inside the probe...

Nice Tank, good growth pics too 8O Keep up the good work and the pics PLEASE :wink:

He purchased it direct from PFO

Anyone heard from or know anyone at PFO? A buddy of mine has the Solaris-I5-48 and 2 of the 4 large LED banks are out, he has been trying to contact them by phone and email for over a week with no success, their voicemail just sends you in a loop. Any help appreciated

My bad, better pic from Oregon Reef here

NVM, i think i found them here http://www.aquaticeco.com/subcategories/3367/Cord-Grips

Does anyone know where you can buy the parts holding the Controller probes in place on this photo from OregonReef? Was thinking of doing a similar setup on my system, and don't know where to get those parts.