Hello,
I have a couple of ideas on how I would like to setup my return lines to the display tank and I am looking for some suggestions. I decided to write them down so you had, well, at least something to look at.
Both return lines in both images would be connected via a Y split from a single pump
The top left most sketch, on line points to the overflow while the other line, next to the overflow points toward the front of the tank
The top right most sketch, only one return line facing toward the front of the tank
the bottom center sketch, both lines are next to each other (the one in the left would probably be in the middle of the tank); the line on the left pointing away from the overflow while the return on the right points toward the front of the tank.
My intentions are to achieve a circular flow through the display tank.
Good idea? Bad Idea? What can I improve on here?
Side question: when connecting pvc together, how do I make the pipes water tight?
I have a couple of ideas on how I would like to setup my return lines to the display tank and I am looking for some suggestions. I decided to write them down so you had, well, at least something to look at.
Both return lines in both images would be connected via a Y split from a single pump
The top left most sketch, on line points to the overflow while the other line, next to the overflow points toward the front of the tank
The top right most sketch, only one return line facing toward the front of the tank
the bottom center sketch, both lines are next to each other (the one in the left would probably be in the middle of the tank); the line on the left pointing away from the overflow while the return on the right points toward the front of the tank.
My intentions are to achieve a circular flow through the display tank.
Good idea? Bad Idea? What can I improve on here?
Side question: when connecting pvc together, how do I make the pipes water tight?