My little dilemma

[Staaan]

I have a drill bit that is 1.75"...

And to create a hole for a 3/4" bulkhead for my 20g long' I require drillbit which is 1.5".

The 1.75" will allow me to do a 1" bulkhead but I an concerned it may be a bit too big for my 20g long.

However the only good I see in using a 1 inch as opposed to the 3/4 inch is that my return pump is quite overpowered for my tank... It's an eheim 1262... Capable of pushing 630gph.

As far as I've read a 1" PVC will drain 650gph so it might not be a bad idea overall? I don't know if I'm thinking about this right.

Could really use some advice...

Thanks!


Sent from my iPhone using Reefs

 

[albano]

IMO...bigger is better! go with the 1" Drain

 

[TimberTDI]

Agree, nothing wrong with bigger.

 

[Staaan]

Thanks guys! That's what I thought. Alrighty drilling the tank tomorrow then.


Sent from my iPhone using Reefs