I think I spent about $200-350. that included a mitre saw rental and some hand tools that I needed for the job. The stand was for a 36"x18" 40G Breeder tank. There are pics of it in my tank thread. the link is below in my sig.
I may be a little conservative on my price, but I defi didn't go over $500. What else do you have to buy? What tools did you need? I only needed a t square and a few drill bits and such. I didn't buy any heavy duty tools.
gotcha. So you're not too far off from the finished product. I suppose the final cost will depend how in depth you are going with the extras like wiring and plumbing. overall, they shouldn't be too bad as far as cost. I went with a stain for my stand rather than paint.
I have spent around $500 so far but that included a three bit router bit set for making raised panel doors but I am getting exactly what I want. Here is my upgrade thread, I am still working on it.
i built a stand and hood for a 120G out of oak veneer and stained it a few years back. It ran about $500 it also included the hardware.
As for the structure i used 2x4 and plywood, i then used the oak panels.
On my 180 with wood, varnish marine grade, silicone, screws, and hinges it came to around $350. I had all the tools or borrowed them.
Also my stand is higher than the norm. It is 72 x 24 x 44, the extra height is awesome in that I can have a larger skimmer and more space to work in all around.