- Location
- Brooklyn, NY
So I got really tired of holding a airline tube in the tank or tying rubber bands to a rock to hold the tubing in the tank so i decided to look online and see what they had to offer for trip acclimation, I saw a item that was simple hard tubing connected to so to soft tubing that had air control valve on the end to control the drips
The company that was selling this was selling it for about $15 and after taking a look at the picture I figured I could do this myself for free with stuff that I already had
I had 3/16" rigid tubing
Some airline tubing
And a air valve
The 2 "tools" i used was
A lighter
A piece of foil balled up and made into a u shape (big enough to fit over the brace on top of the tank)
First I measured out how much I want in the tank I wanted about 3 inches
I cut a 12 inch piece of rigid tubing
Next I started heating the rigid tubing with the lighter (using the blue part of the flame and moving it back and forth slowly about 4 inches) 3 inches away from the end of the tubing
When i saw that the tubing started going limp i placed it on the foil and formed a u shape making sure not to pinch the rigid tubing held it in place for about 30 seconds so it can harden
Then I connected the soft tubing to the other end
Connected a air valve to the other end of the soft tubing
And there you go a drip acclimation kit
Since I wanted more than one I decided to make more I purchased the rigid tubing the soft tubing and more air valves and made some more here are some photos and links to what i purchased to make them
if its to complicated for you i can make it for you for free you would have to buy the materials
One rigid tube makes 3 short (good enough for me) U shaped tubes
Rigid 3/16 in by 3 ft Tubing
https://www.amazon.com/gp/aw/d/B0002APYRM
Soft tubing
http://m.ebay.com/itm?itemId=170860193846
Air valve
http://m.ebay.com/itm?itemId=182050759960
The company that was selling this was selling it for about $15 and after taking a look at the picture I figured I could do this myself for free with stuff that I already had
I had 3/16" rigid tubing
Some airline tubing
And a air valve
The 2 "tools" i used was
A lighter
A piece of foil balled up and made into a u shape (big enough to fit over the brace on top of the tank)
First I measured out how much I want in the tank I wanted about 3 inches
I cut a 12 inch piece of rigid tubing
Next I started heating the rigid tubing with the lighter (using the blue part of the flame and moving it back and forth slowly about 4 inches) 3 inches away from the end of the tubing
When i saw that the tubing started going limp i placed it on the foil and formed a u shape making sure not to pinch the rigid tubing held it in place for about 30 seconds so it can harden
Then I connected the soft tubing to the other end
Connected a air valve to the other end of the soft tubing
And there you go a drip acclimation kit
Since I wanted more than one I decided to make more I purchased the rigid tubing the soft tubing and more air valves and made some more here are some photos and links to what i purchased to make them
if its to complicated for you i can make it for you for free you would have to buy the materials
One rigid tube makes 3 short (good enough for me) U shaped tubes
Rigid 3/16 in by 3 ft Tubing
https://www.amazon.com/gp/aw/d/B0002APYRM
Soft tubing
http://m.ebay.com/itm?itemId=170860193846
Air valve
http://m.ebay.com/itm?itemId=182050759960