What about the table saw blade type?

[hfmann]

No acrylic shop that I know of uses a negative hook angle, if that helps.

Sure does help. I'll keep the one I bought. It's an FS Tool blade, cost $45.00. The freud was about $65.

I'll give it a got his weekend and let you know what I think. It'll be the first cut of acrylic on the tablesaw with a blade made for the job.

Thanks for the help.
Hal

 

[Kabob]

Hal,

Have you made any cuts with this blade yet? Just curious.

Jason

 

[hfmann]

Yes I have Jason. Just to test it. And I think it produced edges just as good as on the pieces we got with our reactor kit. Not as super clean as a router, but looks suitable for gluing to me. I'm going to use it to make a refugium in the 2nd week of April and we'll see how it does on a real project.